-
×
Rockford Fosgate P1S2 15" Subwoofer
1 × $249
Subtotal: $249
Amp Wiring Kits, Rockford Fosgate
Rockford Fosgate RFK8I 8 AWG Power & Signal Installation Kit
Availability:
Out of stock
- FULL spec cable ? meets or exceeds AWG (American Wire Gauge) requirements
- 100% Pure Crystal-Oxygen Free Copper (PC-OFC)
- Includes appropriate wire termination hardware
- 8AWG (8.36mm?) 735 strands
$129
Out of stock
Related products
-
Active Enclosures, Rockford Fosgate
Rockford Fosgate P300-12 Punch Single 12″ 300 Watt Amplified Subwoofer
Active Enclosures, Rockford FosgateRockford Fosgate P300-12 Punch Single 12″ 300 Watt Amplified Subwoofer
The P300-12 powered subwoofer is an ?all-in-one? solution when adding bass to a factory system or just to save space. This model features a 12? subwoofer in a sealed enclosure powered by an internal 300 watt amplifier.
“Closed-loop” design ensures optimum performance between woofer, amplifier and enclosure
Built-in 0?/180? phase switch
Separate low level and speaker level inputs
Built-in adjustable bass boost EQ
Adjustable 12db/Octave low pass crossover
Detachable Power/Ground connector
Intelligent auto turn on/off function
Thermal and over voltage protection
High-efficiency, low current design
Remote bass level control included
Proprietary high output woofer
Constructed with 5/8″ MDF
Large AWG input terminals
Covered with industrial heat activated vinylSKU: n/a -
6" x 9", Rockford Fosgate
Rockford Fosgate R169X3 6 x 9″ 3-Way Full-Range Speaker.
The R169X3 is a 6?x9? 3-way full-range speaker rated at 65 watts RMS for a new generation of factory replacement speakers. Kit includes integrated high-pass crossovers and mounting hardware.
- Vacuum Polypropylene cone
- Rubber surround
- Stamped steel basket
- Silk dome pole mounted Piezo tweeter and midrange
- Integrated tweeter crossover
- Grilles and mounting hardware included
SKU: n/a -
Monoblock, Rockford Fosgate
Rockford Fosgate R1200-1D 1,200 Watt Class-D Mono Amplifier
The PRIME R1200-1D is an ultra-efficient mono amplifier that can produce 1,200 Watts into a 1-Ohm load without taxing the electrical system. The frequency response of the R1200-1D is optimized exclusively for use with subwoofers.
- 12dB/octave Butterworth crossover
- Infrasonic filter
- Remote PLC (Punch Level Control)
- RCA pass-thru outputs
- Real time output and power supply thermal sensing
- Cast aluminum heatsink
- Top mounted controls
- 4 Gauge power/ground connectors
- MOSFET power supply
- Short circuit protection
Number of Channels: 4 Rated Power
(RMS Continuous Power):400 Watts x 1 @ 4-Ohm
800 Watts x 1 @ 2-Ohm
1200 Watts x 1 @ 1-OhmTotal Power
(Sum of Rated Power):1200 Watts RMS Dynamic Power
(PVC/PowerCube?):499 Watts x 1 @ 4-Ohms 0? Res
898 Watts x 1 @ 2-Ohms 0? Res
1,400 Watts x 1 @ 1-Ohm 0? ResBridgeable: No Frequency Response: 20Hz to 250Hz /-1dB Efficiency (average): 85% @ 4-Ohm
85% @ 2-Ohm
80% @ 1-OhmTotal Harmonic Distortion(THD Noise): 4-Ohm: <1.0%
2-Ohm: <1.0%
1-Ohm: <1.0%Crossover Controls: Low-Pass: Variable 50Hz – 500Hz @ 12dB/Octave
Infrasonic:Tone Controls: 0dB to 18dB @ 45Hz Input Sensitivity: 150 mV to 4 V Signal Input: Low Level: 1 RCA Pair Signal Output: Low Level: 1 RCA Pair Power Input Connector: Block Power Wire Gauge: 4 AWG Speaker Output Connector: Block Speaker Wire Gauge: 12 AWG Heat Sink Type: Cast aluminum Cooling: Convection Remote Controls: Variable 0dB to 12dB @ 45Hz Visual Indicators: Power
ProtectCircuit Topology Class: Class-D Operating Voltage: 9 – 16 VDC Recommended Fuse
(not included):150 A Max. Current Draw (13.8V Sinewave): 110 A Average Current Draw (13.8V Music): 55 A Suggested Alternator: 100 A Shipping Weight: 7.825 Lbs. (7.82 Kg.) Dimensions (H x W x D): 1.97″ x 6.77″ x 11.06″
(5cm x 17.20cm x 28.10cm)SKU: n/a -
12", Rockford Fosgate
Rockford Fosgate P2D4-12″ Subwoofer
his P2 sub features an extended pole piece and bumped backplate that leaves more room for heavy excursion, so it’ll hit deeper lows without “bottoming out.” Special venting keeps the copper-clad aluminum voice coils cool through heavy use for consistent bass performance over time.
The dual 4-ohm voice coils allow you to wire the sub for 2-ohm impedance to work with a mono sub amp, or for 8-ohm impedance if you’re using multiple subs. The P2D4-12 sub works equally well in a sealed or ported enclosure, so you can choose the kind of bass you want for your system.
To drive this single subwoofer, we recommend a mono amplifier rated between 300 and 600 watts RMS at 2 ohms.
Product Highlights:
- 12″ subwoofer with dual 4-ohm voice coils
- Kevlar? reinforced paper cone
- Santoprene surround
- hybrid StampCast basket provides strength while minimizing weight and resonance
- power range: 150-400 watts RMS (800 watts peak power)
- frequency response: 27-250 Hz
- sensitivity: 86 dB
- top-mount depth: 6-3/8″
- sealed box volume: 0.70-1.80 cubic feet
- ported box volume: 1.79 cubic feet
SKU: n/a -
10", Rockford Fosgate
Rockford Fosgate P3D4-10″ Subwoofer
Product Highlights:
- 10″ subwoofer with dual 4-ohm voice coils
- anodized aluminum cone with Santoprene surround
- hybrid StampCast basket provides strength while minimizing weight and resonance
- Vertical Attach Surround Technique (VAST?) increases cone area
- power range: 250-500 watts RMS (1000 watts peak power)
- frequency response: 28-250 Hz
- sensitivity: 82 dB
- top-mount depth: 6-3/16″
- sealed box volume: 0.5-0.75 cubic feet
- ported box volume: 1.4 cubic feet
SKU: n/a
